Roof TV installationWhether the TV is necessary in the car? Now I can tell with confidence: if you have small children and you go on a long distance it is necessary. Really helps to brighten up long sitting in a children's armchair with the fastened belt. So the small report on installation of the roof TV.
As for beautiful installation it is necessary to remove completely a roof, i made at the same time a full noise isolation. Used materials STP: vibra - Gold 2 mm, noise insulation - accent of 10 mm. At dismantling of a roof no difficulties have arisen, all is very in detail described at a forum. The most difficult was to tear off factory felted cloth. 2-3 hours of killed time. Results on a photo.
Near to a wire for the central light I laid an "+" and "-" wiring for the TV. An installation site has chosen at once behind a rear plafond of illumination. As a variant it is possible to clean completely a rear plafond and to displace the TV forward. As in a TV set there is a function of inclusion of lamps of illumination at opening of doors through an additional steering minus. Nevertheless, i decided a rear plafond to leave. The new wire has fixed with the "splen".
Further on a TV installation site has fixed a dural plate for TV fastening. The form and the size of a plate depend on concrete model of the TV and a place of an exit of wires from TV set cases.
Plate has fixed on regular longerons of a roof through a material.
Then, after roof installation, it is put bottom (or top, looking whence to look) the cover of the case of the TV and in a place, through the established roof, bores in a dural plate are drilled. Then in bores a tap we thread under screws.
After that accurately we cut out a bore in an upholstery of a ceiling for a wiring. Establish the case of the TV. After TV set fastening it is necessary to connect only wires in a window of a plafond and to hide them under a roof that they did not disturb to installation of the plafond.
Then has connected wiring. All connections has made in a front left side.
In wiring pad it was found out homeless "+" wire, wich did not vanish at deenergizing of ignition and key extraction. I connected a "+" wire from a TV set (with a fuse). The "-" has connected on a wire from outside roofs (that it was more convenient to undress and solder a wire)
All wires in a rack has fixed with the "splen".
It is necessary to put the rests of a covering of interior only.
And after adjustment of frequency of a regular audiosystem on Fm-transmiter the TV it is possible to enjoy result.
10.jpg